start to use a gsm camera step by step (mms sender)
I. Insert a clean and prepaid sim card.
II. Plug in power adaptor and turn on power switch.
III. Configure master mobile phone number.
IV. Configure MMS parameters in this link.
V. Mounting camera in suitable location and enjoy it now.
alarm states of gsm camera (mms sender)
Alarm is running
Speaker alarm, report sms alarm message, report mms photo alarm, send live photo(s) and dail programmed phone numbers.
Alarm deactivating
All sensors deactivated. Call or send message to ask live phone or listen on-site voice are available.
Activating the alarm
Send message, make a call to GSM camera to activate alarm state along with external sensors. Push lock button on remote control is okay also.
Stopping running alarm
Type command 1#0# on key pad in conversation or send it by message to stop alarm states. Push unlock button on remote control is workable also.
Indicator lights of gsm camera (mms sender)
GREEN light lasting indicates alarm deactivated
GREEN light flashing indicates alarm state is activated
RED light blanking indicates running a alarm
RED light flashing indicates receiving or sending datas
ORANGE light flashing or lasting means some errors happened
default setting of a gsm camera (mms sender)
Cue tone when push remote control
Speaker alarm when running a alarm
Report MMS and SMS alarm when running a alarm
Both camera and body sensor are actived
Send photos to mobile/email incessantly
mms parameter setting
Check existing data - password#40##
Set APN - password#41#apn#
Set User's Name - password#42#name#
Set Password - password#43#word#
Set IP Address - password#44#IP#
Set MMSHome - password#45#homesite#
how to use the reset button on side panel of gsm camera (mms sender)
I. Reset to default settings - Push and switching power on, hold 3 seconds, light become red. done.
II. Learn new sensors - push 1 second is okay.
how to use a remote control to control a gsm camera (mms sender)
Push lock button to activate alarm state.
Push unlock button to deactivate alarm state.
Push bell button to running a emergency alarm state.
setup more wireless sensors for gsm camera (mms sender)
Push reset button for 1 second, light turns red. Then shoot the sensor. Heard beep, is ok.
commands dictionary | for control the gsm camera (mms sender)
Please see detail commands in page two of user's manual. Download here.
remarks to commands
I. Max two email address.
II. Control the GSM camera by telephone - type keypad when in conversation.
III. Comand format is passward#command".
IV. Solid memory system, no need re-configure after power off.
V. Telephone number must comes with zone number.
VI. Legend of the commands.
operation remarks
I. SIM card must be clean.
II. Change default password once after get it.
III. Keep away from electronic wave sources.
IV. Switch off power when insert or take out a SIM card.
V. Checking batteries in sensors and remote control(s) termly.
VI. Check balance in SIM card termly.
VII. For indoor use only.
VIII. Keep camera away from direct strong light sources.
